3×1 timber is a nominal size of 3 inches by 1 inch. Once planed all round (PAR), the finished board is typically around 70mm x 20mm. Treated 3×1 has been pressure treated against rot and insect attack, which makes it suitable for outdoor projects such as slatted screens, battens and garden structures. It isn’t a structural timber.
Few timber sizes cause as much confusion as 3×1. The name comes from old imperial sizing, but the board you receive is smaller than either number suggests. Knowing why saves you cutting errors and wasted material.
What size is 3x1 timber in mm?
The “3×1” label describes the rough sawn size before planing. Planing removes a few millimetres from each face, so the finished size is smaller. CMR Timber lists its planed treated 3×1 as 20mm x 70mm .
Label | Typical finished size | Notes |
3×1 (planed all round) | about 70mm x 20mm | Smooth on all four faces |
3×1 (sawn) | nominally 75mm x 25mm | Rougher, usually slightly larger |
Planed sizes vary slightly between suppliers. Check the finished dimensions on the product page before you design around a specific width.
Planed or sawn: which 3x1 should you buy?
- Planed all round (PAR): smooth, with consistent edges. Best where the timber will be seen, such as slatted screens, trellis and decorative framing.
- Sawn: rougher and usually cheaper. Better for hidden battens or a rustic look.
For a neat finish, choose planed. For concealed framework, sawn is often enough.
What is treated 3x1 timber used for?
Treated 3×1 suits lightweight outdoor jobs:
- Slatted fence and screen infills
- Battens for cladding. See our treated timber cladding guide for how battens and boards work together.
- Trellis and garden screening
- Planter and bench slats
- Small garden frameworks and edging supports
Treated timber is the better choice outside because the preservative protects the board against fungal decay and insect attack. For how long to expect it to last, see How Long Does Pressure-Treated Timber Last?
Is 3x1 timber strong enough for structural use?
No. A 70mm x 20mm board is too thin to carry loads such as roof or floor joists. Use graded structural timber for those jobs. Treated PAR boards are best treated as cladding, slats, battens and trim.
Treated 3x1 and ground contact
Treated timber isn’t automatically suitable for burying. Treatment levels differ, and boards intended for above-ground use shouldn’t sit in soil. If a board will touch the ground, check the product’s stated treatment class first and ask us if it isn’t clear.
How much 3x1 do you need?
Work in linear metres. For a slatted screen, divide the width by the slat width plus the gap you want, then multiply by the height of each slat run. Allow roughly 10% extra for offcuts and defects. CMR’s treated planed 3×1 comes in 3.6m lengths, so plan cuts to minimise waste.
Always seal cut ends with a suitable preservative, as cutting exposes untreated timber.
Where to find treated 3x1 timber
You can buy it from our fencing range or order a sample first. Use corrosion-resistant fixings outdoors. Trade buyers can apply for a trade card, and the delivery page covers UK delivery. For advice on a specific project, call 0113 345 1617.
